Jump to content

Weight-Forward Spinners From Scratch


diemai
 Share


To fix and position the front wire shaft reliably to the brass weight I've furnished a little groove with my "Dremel" cutting wheel and extended it lengthwise a bit with a small 1,5mm router bit .

The shorter tag end of the front shaft's open wire loop is bent and pulled back into that groove(after having connected the rear spinner shaft)with pliers , snipped off and ground flush to the brass drum's circumferrence .


Photo Information for Weight-Forward Spinners From Scratch

 Share


Recommended Comments

There are no comments to display.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...
Top