Couple of home made swimbaits

Sign in to follow this  

finally had enough time to finish couple of swimbaits that i have been working on, everything about these baits was a huge challenge for me, witch is nice, i do love a good challenge :D

you can check out how they swim from here

Sign in to follow this  

Recommended Comments

Nice job as usual. I have made a few swimbaits from resin with a similar hinge as well. With the pin so close to the edge, and so little material, I had doubts about the overall strength and ability to hold together under the forces of a twisting Pike or Musky. Do you have some kind of reinforcement like stainless loops or complete wire through? Nice carving, sweet swimming action and as always, beautiful paint work.


Share this comment

Link to comment

that is still something i have to test still ,i could always add reinforcement stainless steel rings inside the joints to add more strength to the joints if it seems that i need it, but so far it seems that i cant brake the joints when i'm twisting them with all the strength i have, i use smooth cast resin and it seems to be very tough stuff .

Share this comment

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now