Jump to content

- - - - -

CNC Layout

cnc poly foam

CNC Layout

Here is a cut out from the CNC machine. Only the inside is shaped with the CNC. It allows me to get the weights exactly where I want them and the wire track is dead center. Once the two mirror image halves are put together with the weights and wire in place a couple drops of CA glue finish the assembly. Final shaping, paint, and topcoat finish the job.

Lip slot if needed and some basic surface shaping should be done before assembly!

Any and all feed back welcome.

    • VermontPhisher likes this
    That's sweet! Must be a lot of work after the CNC but it's sweet!