Jump to content

- - - - -



Finished product runs nicely...for my 1st foray into custom crankbaits. I gopro'd it at posted the vine to my instagram account tnrbaits17. Making the hole in the bill was the vital part as far as positioning goes.

    Nice looking crank....like the color scheme...curious as how the tie is anchored in the bill....any secrets??? thanks, mike

      • Ric670 likes this
    @surfk9 I drilled the hole in the bill..made a loop in the wire to be just slightly larger than the hole, then folded the tag end of the wire under the bill..cut the tag end. I then epoxied the bill in to the body. VOILA...that bait runs as good and as straight as any you buy in the store. I hope that helps

    Thanks for the reply....i'll have to try that....surfk9