dragonfly popper

Wings cut out from old milk jug... Should be just strong and flexibke enough to work.... Excuse the paint job, not my best attribute


Recommended Comments

Thanks!... Havnt tested yet, i dont expect it to cast well with the wings, but as long as they don't drag it under on the retrieve itll work

Share this comment

Link to comment

Tested today... Every problem i anticipated happened... Hard to keep it right side up cause the wings wont let it roll over... Even though i weighted it in the rear to keep the front up, wings still make it dive... But, it casted better than i expected........ Back to the drawing board, not giving up on the dragonfly, but have an idea for a different design.... Give me a couple weeks and hopefully ill have somthin to show!

Share this comment

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now