Jump to content

Custom Pull Pin From Repurposed Material 1 of 4


fshng2
 Share


Material: 

1. Hard wood handle is salvaged from a broken rubber mallet.

I knew I saved this for a reason.

2. 1/8 Hard stainless wire .o62 with loop.

This was purchased but  not used because it was too hard for a thru wire lure construction (cost .99C).

 Process: 

1. 1/4" Counter bore   5/16" deep.

2. .0627 holes 2ea spaced as shown.

3. Cut handle to desired length.

I cut mine to allow material to extend past my hand on both sides when held.

4. Insert SS wire and trim to fit mold; then smooth cut end.

5. Wire is held securely with friction.

If wire is ever needed to be replaced just push out the old one and replace with a new one.

 


 Share


Recommended Comments

There are no comments to display.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...
Top