Jump to content

Front weighted spoons


diemai
 Share


Also a part of the request of one guy to make some special spoons for him , that would already wobble at the slowest speed of retrieve , and would also have a little different swimming pattern as commercial spoons .

He came up with a working instruction , that he had cut out from a magazine and so I got started .

Those spoons are moderately cupped , their special feature is a weight of solder , applied onto the inner front portion of the spoon .

Never made such spoons before , and I tried to keep close to those , not too accurate , instructions .

In fact , the wobble of the finished spoons was in a way different , they "swing" from one side-edge to the other , don't have much of a "wave"-pattern , but also cause some vibration , felt down to the rod tip .

I am still uncertain about these spoons , but after I sent out the spoons to that guy , he called and told me , that they turned out exactly the way , that he imagined them to be , so now , after closing time on the 1st of May over here , the local pike are going to have the last word about my creations:wink::huh:;) !

Questions ? You're welcome :wink:! diemai


 Share


Recommended Comments

There are no comments to display.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...
Top