Swimbait Family

Cami
Sign in to follow this  
Followers 0

Here you are a Family Swim bait Picture. In the back there is Dad, a block of graphite handily sculptured by myself. Family is supported by Mum (as usual), a block of aluminium electro eroded by Dad. From left to right: White, Poured Painted and Dipped, Black and Laminated,

Bye

Cami


  Report Image
Sign in to follow this  
Followers 0


5 Comments

They swim quite good, don't think to the Javalon movement, the tail has a frenetic side to side sliding. Best rig has been obtained with a weighted swimbait hook. Mum thinks that fat is beautiful.

Bye

Cami

Share this comment


Link to comment

Very Nice!

Question? how long was the electro erosion process for that mold? (not counting setup & design, just actual erosion?)

Thanks for posting it.

Share this comment


Link to comment

I worked in a Fine Blanking Factory that usually uses copper machined electrodes for steel mold. It has been first time that they used graphite and aluminium, said that we spent around two hours for each side, worked in different moments, in fact you can see on plastic output a mismatch mistake between two halves. After this "experiment", made for joke, they discovered a lot of improvements to realize same mold in less time and especially without mistake ... but it is not their core buisiness.

Bye.

Cami

Share this comment


Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now