eyemafish Posted January 20, 2013 Report Share Posted January 20, 2013 I'm looking to make some more cups for my fluid beds. I seem to have bad luck using coffee filters and paper sacks as they always end up tearing and I get the paint everywhere. I bought a few of the cups from TJ's Tackle. What is the name of the filter board people use for the bottoms of the cups and where can I purchase it? Thanks Quote Link to comment Share on other sites More sharing options...
Kasilofchrisn Posted January 21, 2013 Report Share Posted January 21, 2013 It's called fluidizing plate. I recently bought some on EBAY. Check out this thread. http://www.tackleunderground.com/community/index.php?/topic/25695-fluid-bed-plate-source/ Quote Link to comment Share on other sites More sharing options...
Fatman Posted January 30, 2013 Report Share Posted January 30, 2013 You cold check McMaster-Carr - Helps if you have some info about the stuff first. Quote Link to comment Share on other sites More sharing options...
gonfishn Posted February 2, 2013 Report Share Posted February 2, 2013 The Ebay source is a great supplier as I've bought some of his material myself, however, unless you're working with a bit more air pressure than most "at home" lure builders, you'll probably want to try to corner some of the 1/8th inch instead of the 1/4 inch for sale on Ebay. CSI and MC both sell fluidizer plate in the size you need but runs around 75 cents a square inch. Quote Link to comment Share on other sites More sharing options...
