Vandy Posted February 15, 2014 Report Share Posted February 15, 2014 I have been getting a lot of bubbles in my etex lately and could not figure out why. So I went to their website and reread the instructions. This is what I found: "Mixing EnviroTex Lite® when cold can result in cloudy pours with microscopic bubbles." They recommend warming the bottles in a hot water bath if the temperature is below 70 degrees, which it definitley is in my basement. Hopefully this will help someone else. Quote Link to comment Share on other sites More sharing options...
mark poulson Posted February 15, 2014 Report Share Posted February 15, 2014 When I used Etex, I'd warm the bottles with a hair dryer, so it would flow into my syringes, and then heat it again after it was mixed, to help get rid of the bubbles from mixing. 1 Quote Link to comment Share on other sites More sharing options...
