fishhook Posted July 30, 2014 Report Share Posted July 30, 2014 Does anyone know the I.D. of the (round) end of this do- it mold finesse swivel ? Quote Link to comment Share on other sites More sharing options...
cadman Posted July 30, 2014 Report Share Posted July 30, 2014 (edited) Inside diameter of the Do-It brand swivel is as follows: Inside caliper jaws measured at (.060) Pin gage that fits in there is (.0605) FYI, there are a lot of generic brands out there. I bought these from Do-It about 4 years ago. Hopefully the quality in the past is the same as they are making currently. Edited July 30, 2014 by cadman Quote Link to comment Share on other sites More sharing options...
fishhook Posted July 30, 2014 Author Report Share Posted July 30, 2014 Thanks Cadman :-))) Quote Link to comment Share on other sites More sharing options...
BuckMaxx Posted August 20, 2014 Report Share Posted August 20, 2014 I use them in my do it mold just fine. Cheapest palce I have found in bulk is on ebay. Quote Link to comment Share on other sites More sharing options...
