Senkosam Posted February 4, 2005 Report Share Posted February 4, 2005 Okay, how did I do it? The swirl is a spiral that goes the length of the worm. Quote Link to comment Share on other sites More sharing options...
Mattlures Posted February 4, 2005 Report Share Posted February 4, 2005 I dont know if this is how you do it but, I know how to do it. You pour it like a laminate. 1st you pour 1 half of the worm. 2nd you pour a zig zag vein. 3rd put the mold together and fill it up. Quote Link to comment Share on other sites More sharing options...
Senkosam Posted February 4, 2005 Author Report Share Posted February 4, 2005 Very close! I took a thin wooden skewer, molded it in plaster and poured a thin vein. The laminate process was correct, but the vein was laid out straight on the poured half. With the mold upright, once the heat of the second pour hit the vein, it made it settle into a coil that spiraled around inside the hot plastic. Good thinking! Quote Link to comment Share on other sites More sharing options...
