Jump to content



Photo
- - - - -

Wire bending tools?


  • Please log in to reply
3 replies to this topic

#1 Brad

Brad

    Member

  • TU Member
  • PipPip
  • 86 posts

Posted 20 October 2005 - 05:13 PM

I want to try to make my own wire leaders for muskie fishing. I will be using .029" wire and the finished product will be 12" long with wrapped loops on each end. my question is, can the Boggs Tacklemaker or Hagen's Bender make 12" wrapped leaders or are they too long for the machines. Thanks.

#2 dlaery

dlaery

    Advanced Member

  • TU Member
  • PipPipPip
  • 642 posts
  • Location:
    Warsaw, Missouri

Posted 20 October 2005 - 08:38 PM

I bought the Hagans and plan on doing bottom bouncers. I was told that it would work fine for that. I have not tried it yet.

#3 Pop

Pop

    Advanced Member

  • TU Member
  • PipPipPip
  • 412 posts

Posted 20 October 2005 - 09:37 PM

Boggs makes an extension for longer wire. Check their website
http://www.tacklemaker.com/home.html
Plaster of Paris

#4 LedHed

LedHed

    Advanced Member

  • TU Member
  • PipPipPip
  • 792 posts

Posted 21 October 2005 - 08:27 AM

Brad
If all you are going to do is leaders, you are probably better off making a jig on a board with two nails. Some flush cutters and wire bending pliers and you're set.
Wire benders and spare parts can get expensive. Check out eBay for used benders. Herter's are the same as Cabela's and Thompson's are the same as Bogg's.