jigmaster Posted January 22, 2006 Report Share Posted January 22, 2006 Hey, all anybody out there have any experience with making tail spinners........am wondering what the wire diameter is on the wire insert for the do-it mold, (TS-28)and also the length of the shaft on the wire insert any ideas? thanks JM www.daimonlures.com Quote Link to comment Share on other sites More sharing options...
Elken Posted January 25, 2006 Report Share Posted January 25, 2006 I have some of the forms at home; I will try to remember to mic some out and post the diameter. It is fairly thin wire; I guessing it is i the neighborhood of 0.030". The form is about 4 or 5" long; again I will measure & post. Quote Link to comment Share on other sites More sharing options...
jigmaster Posted January 25, 2006 Author Report Share Posted January 25, 2006 hey, elkins thanks for the help, and the info regards JM www.daimonlures.com Quote Link to comment Share on other sites More sharing options...
Elken Posted January 26, 2006 Report Share Posted January 26, 2006 The Tailspinner forms are 0.028" diameter and 1.92" long. They are shorter than I remembered; all I remembered is that they hung down below the mold and I had to move the mold support bar on the lead pot. Quote Link to comment Share on other sites More sharing options...