Chuck Young Posted August 22, 2016 Report Share Posted August 22, 2016 Get a smoother finish and coat more baits faster with this epoxy brush. Get a cheap set of bristle brushed (Walmart is one source). Use a pointed pair of scissors to remove 3/4 to 7/8 of the bristles. Clean with denatured alcohol or acetone and wrap with paper towel. Reuse it for months or years. Quote Link to comment Share on other sites More sharing options...
RayburnGuy Posted August 22, 2016 Report Share Posted August 22, 2016 That should make the brush softer so I can see how that would help keep bubbles out of the finish. Only drawback is that it might not allow you to load as much epoxy onto your brush. May have to give this one a try though. Thanks Chuck. Ben Quote Link to comment Share on other sites More sharing options...
Chuck Young Posted August 23, 2016 Author Report Share Posted August 23, 2016 I don't have a problem with bubbles. It holds quite a bit, epoxy flows well. One swipe covers about one side of a 4-1/2" slim minnow. I use stencil material to scrape most of the epoxy out of the brush before cleanup. Quote Link to comment Share on other sites More sharing options...
Eyectcher Posted August 27, 2016 Report Share Posted August 27, 2016 Hey guys hope everone is well guys I was clear paint some baits one night and the brush kept lose ing strands on the lures so with two baits left And the epoxy starting to harden I used my finger with a nirele glove on and it's the best finish I've ever got with devcon hope this helps Quote Link to comment Share on other sites More sharing options...
Chuck Young Posted September 1, 2016 Author Report Share Posted September 1, 2016 Thin epoxy applied to base of bristles, brush left standing bristles up, will set your bristles permanently. Quote Link to comment Share on other sites More sharing options...
