Jump to content
russ

need info..

Recommended Posts

You can check out some of the tutorials on this board and get a good idea of how it's done. You don't need much; wood, Devcon 2 Ton epoxy, stainless steel wire (I use .029" 180lb test leader wire), a 12"x12" sheet of polycarbonate (e.g. Lexan) for the lip (if needed), lead or silver solder and a soldering iron to put in the ballast, and whichever colors of aerosol latex paint you like (and use a flat white to basecoat before coloring). I use a disk sander to taper baits and a Dremel sanding drum to round off edges. You will probably want other tools and supplies to fine tune subsequent baits but this short list will do to start.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...
Top