Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 08/09/2020 in all areas

  1. By volume. In past has been suggested to substitute MEK with THF, but I prefer MEK. As retarder has been suggested to use Ciclohexanone (I'm not sure how it is written), but I have never found it. @ Toadfrog: do you transfer decals over plastisol baits? Bye Cami
    1 point
  2. When using pvc glue and MEK it's best that you don't use a transfer decal or anything like that on the bait. This mix will deteriorate the decal.
    1 point
  3. It depends on the hardness of the brass versus the steel and either metal can be tempered to similar or very different hardness. However hard temper stainless is tougher than hard temper brass and it won’t corrode. Jmho, we put so much time and effort into a hand built crankbait that the cost of raw materials like wood, wire and screw eyes is negligible. So I say buy the good stuff.
    1 point
  4. Too pretty the fish won’t like it throw it away and start over nice work mark
    1 point
  5. This simple recipe 50 PVC glue/50 solvent dries really quickly, so you have to prepare this mixture just before to brush it. The main idea is to create a varnish solvent based, like that of SpikeIt, so you can apply it also with an airbrush pen and you do not need anymore any kind of top coat. In some posts here on TU there are some suggestions about more efficient recipes, but I couldn't find the right one till now. Bye Cami
    1 point
  6. Here is some info on them. Don't know about knockoffs.
    1 point
×
×
  • Create New...
Top