kbiddle

Hi fellas, Anyone know where I can get a zoom U-tale like mold... Yes I have tried making it however I am at the point I would really just like the aluminum mold.... Also what are your thought on this in a standards or should it be a 2 piece mold? Thanks in advance... Kevin

OK, Guy's I have looked and looked and I have not seen any suggestions on a 2 part resin mold? What are the thoughts on this is is possible ? I want to mold some bitter rodent types for full round soft pours, the flat are fine but I want to tryt and get a full body. Any insight you could give me would be greatly appreicated... Thanks Kevin

Fin, Should be no issue just besure that plastic is a correct temp to either get the seperation or not... cooler equal better spe hotter equals more bleeding of the colors in my experience..

Actully I discovered the same thing... But I also discovered in the resin mold if you come in from the top with like a 1/32 or so drill and go down to the flap cavity it seems to give the air someplace to escape and helps the flap come out much better.... Kevin

Guys, Has anyone attempted to do a resin mold of the ever popular Beaver? I am considering doing one for the smaillie and just would like to get your all feedback? Thank in advance. Kevin

I would have to really agree with you all on the quality issue of the beav molds form lure craft I think it is not very good and does a poor job of representing the flap... Just my $.02 worth... but I am not bale to locate the alluminium one anywhere....

Earthworm where did you get the alluminum mold I have been trying and trying and trying to get my hands on one to now avail.... Help please? Thanks Kevin

Senk yes they ae LC molds ... not quite as good pf detail I was hoping for... I may try to make my own mold to see if the representation get any better I am really looking for an alluminum one but have not been able to locate one as of yet... Kevin

HEre are the first pours let me know whay you all think.... Thanks Kevin

1996 209 TE Gambler...

OK I guess a little more newbie questioning may be in order... In regards to which formula # hardener I could use a little advice in that area if it would not be too much to ask...any other tips would also be appreciated.... Again thank you.. Kevin

Got em thanks a bunch guys will be my first project... I think I have read about every post on here in the last week or so time to jump in and get my feet wet... You all seem like a really good bunch have really enjoyed and learned allot from all the articles... Thank you Kevin

Thank you wood... Kevin

Does anyone have a website address for the locations to get these molds? Thanks Kevin