randyaf

Thanks I understand how to do this now . thanks again everyone randy

will these blades attached this way separate from each other and spin independently from each other or will they constantly stay together and try to spin as one blade or does this cause an irregular spinning action?

I cant figure out how to put two spinnerblades on an inline spinner. Do you put both blades on the same clevis or do you use two clevises and kind of intertwine them on the wire? Thanks Randy

Minwax has great sealers . Another one that I use is the waterbased polycrylic by minwax in the blue can. It comes in different finishes. I use the clear gloss.it looks like milk in the can but dries clear and very hard.

When recycling your old baits, is there anything that i can mix with the plastic other than hardener to make baits alittle firmer.

That looks great .I would think that would work just fine. I would probably have to downsize it. How deep does it run. Also would it troll ok?

I would like to make a couple of walleye cranks to run in 5 to 15 feet of river water. If anyone here walleye fishes, what crankbait would you recommend that I copy. I would like to stay at 3.5 inches to no less than 2.5 inches. And also would you recommend cedar or not. Any help would be appreciated. I've done alot of looking at commercial lures but $6.00 to $8.00 each would be costly experimenting. Thanks Randy

What is the best way to correctly size the lexan lip to the lure? I know that the angle determines the depth. I need to know how to determine length vs width to get the correct action. Thanks.