RGR5RTB

I need a recommendation on a good heat gun for heating jigs and where I can order it from. Thanks

Sorry did not mean that used the same brush I was using for epoxy just the same cheap throw away type brush that I use with epoxy. As for the paint I do not use white powder paint very often so it is old but it has remained in the jar in the shop. It does not appear lumpy or wet in the jar. I am going to get a new jar of paint just to make sure that is not the problem. I am very interested in a fluid bed that will work with SB's. I would prefer to use powder paint on everything. Maybe just spray on the accents. Something I am going to try is to cut 2 slits in an empty paint jar for the hook and wire and put a small amount of PP in it and just shake it on. Thanks to all that replied I have learned alot off this site.

Thanks guys I will try these things you mentioned. The brush I was using was a throw away that I use for epoxy that may be the problem or the Powder paint is old and could be wet.

I have a question about powder painting SB's. I have tried tapping it off the brush onto the heated SB but it always comes out very lumpy. I tried heating it in the toaster thinking it would run enough to smooth it out but that did not work either. Any suggestions as to where I am going wrong?

What is the best type of paint to use on SB's ? I have been spraying with createx but any imperfection with the pour shows thru. Thanks

I am betting this has been covered before but I can't find it, what is the best kind of pliers to make the loop at the end of the SB wire. I have the step jaw round nose but was looking at the nesting pliers and round nose pliers.

Thanks Ben, it is ironic that you were the one to reply, I ordered a fluid bed from you last night. Mike Moore

Guys this has probably been covered before but what are you using to cure powder paint? I have been using our home oven but the wife put a halt to that. I was considering a convection oven but it is a convection/microwave and I didn't know if that would work with the metal. Any help would be greatly appreciated.