andydoc

x3 on jacobs

x5...Just ordered another crappie mold from Jacobs...

I know larry dahlberg did it just that way in one of his videos...but can't remember which one http://www.makelure.com/HowTos.cfm Enjoy all his vids...very informational

My travel vice is a Terra Spring Vise...knock off of a regal INEX Vice I purchased from J-Mac Lures Terra Vises at J-Mac ...and it has some pretty good holding power. Can't go wrong with Griffin... Griffin Vises at J-Mac

I haven't done any searching yet, but can plastisol or equivalent be rotational molded?

You guys are the best. It is a dip bait holder...made by Uncle Josh. They sell a tube of stink bait to squish in the middle (see attached). Was thinking it would be neat to make some type of stink bait holder in the form of a shad or something. Just a different take on a current idea...

See attached. It has a big cavity in the middle. Looking for some ideas from the experts...

thanks for the link...very intersting and educational. I am just trying to pour a round worm very similar to this (attached). Not knowing much about the process, any opinion if PoP would be the best choice to start with?

thanks all for the response. I did do alot of research last night. Found some very educational videos from Larry Dahlberg. I am not looking at production, but am a do it yourselfer. I have an uncle that has a 'favorite' worm that is out of production and would like some more. I want to help cause I have seen what those worms are capable of. I need to do some more looking to if some company has already made a mold of the worm.

any pointers as to who sells them? It is kinda hard to tell from pictures and the literature on some websites

I am doing a little research, and was wondering if there are 2 sided molds that can be hand poured. I did some searching on this forum, but didn't get any hits. I am looking to get into the soft plastic world, but don't have the dough to get into the injection world. Any guidance is greatly appreciated...

I did a search on the forum with no hits...but what else is involved with the vacuum forming process? What is used to glue the halves together? How are the hook holders attached... also...what is more cost effective...vacuum forming a crankbait or pouring complete plastic? thanks