ohioskeeter

What do you all recommed for a base coat on plastics and woods? I used Fusion on the plastics and the createx water based won't stick or at least for me it won't. Please give me a product from createx, I like their products and seem safe. Can I just use the createx white as a base? Thanks

Where is the best place to order eyes? Can someone tell me what I need to make precise lines with a Paasche Vl series brush? Be specific, I'm a rookie getting better from your all suggestions. Thanks

What store carry it on-line? Also, will fusion white work as a good primer? It is oil based I think. Thanks

Bob, How do you match them up? and does the needle extend outside the cone? Mine do sometimes. The instruction manual with the set stunk. Thanks Eric

Like I posted earlier, I'm new at this technique. What tip and needle do you recommend to paint crankbaits? Also, the set I have spits all the time, could it be the needle or the tip or both? The one needle looks bent but the other looks fine. Thanks

Where do you get the templates? And thanks for the advice. I am still getting the spitting on my baits. I have cleaned it well (I think). How do I match up the tip and the needle, maybe that is my problem. Thanks:)

Guys I bought a face mask with 100 filters and after painting last night I was sick and a little dizzy. I painted in the garage with the door open. Should I wear safety goggles/glasses? Also, any suggestions on how to ventilate. I have no room for a paint booth just a garage. Also, do you tape off what you have done when painting a bait a different color in another area? Thanks Ohioskeeter

I have just started airbrushing and needless to say I am poor at best. I have just a few short answer questions because I know you get these questions all the time. Before painting a plastic bait (ordered from Jann's Netcraft) do I need to prepare the bait for airbrushing? Such as a primer or sanding? 2nd, after each coat do I put on a top coat (or whatever you name the clear gloss)? And if so what kind do you recommend. I have read many posts on here and the process takes a lot of hard work. I know that and am willing to put in the time. Right now I struggle with the Paasche VL with it spitting all the time. I clean it and about 1 minute later it starts spitting. Any suggestions? I use createx water based paint. I bought lacquer paint and tried it tonight because I didn't know better and it was messy. Do you painters use lacquer paints in an airbrush? I appreciate any help or suggestions. Ohioskeeter