riemanbt

I am using commercial lips. I didn't know if Anyone had a trick to make the slot to just the width of the lip. I was trying to avoid using glue or filler to fill in the corners. Thanks for the advise!

I usually cut out the slots for my crankbait lips with a bandsaw, but it leaves gaps on each side of the lip. Does anyone have a solution to cutting out lips without making these gaps?

If you go to the main Forum page you can scroll down to the tutorials, in the hard bait section their is one post that has a few videos. I think that it would help a lot!

Try taking the needle completely out and cleaning it. chances are their is just something stuck in the chamber. If the nut that holds the needle in on the back of the brush is not tight the the needle will not pull back and nothing will come out. hope this helps