Jump to content

vipor3d

TU Member
  • Posts

    2
  • Joined

  • Last visited

vipor3d's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. I know I cant with the equipment I have, because I do not really have much. Like I said, I'm new at it. I've pretty much just been experimenting with old baits and homemade mold shapes. I'm not trying to start churning worms out overnight or anything like that. I was just asking about a higher cavity mold just so I can get an idea of what sort of equipment I might would need to look into as I figure things out more and develop my little project. I understand that a 10 cavity u tail mold would be quite large and expensive, but would that be more expensive than buying five two-cavity molds? Also, wouldn't having a fewer number of higher capacity molds instead of more lower capacity molds decrease the amount of time I would have to spend opening and closing the molds to remove the baits after injection?
  2. I am fairly new to the process of pouring my own baits and have been doing a lot of looking into various molds. I am particularly interested in making 6 to 7 inch u-tail like worms and have already had a few people ask me to make some for them, which I do not mind doing. However, it seems that every mold I can find for this type of worm usually only has two cavities. It would seem to me that even with multiple molds it would be rather time consuming to make up enough worms for other people when the molds only have two cavities, and especially if I wanted to make worms of multiple colors. I have been trying to find molds that would allow me to make maybe ten or so at a time but I cannot seem to find anything like this for the size and type worm I am going for. Is there a reason that higher capacity molds are not produced like this? Or do higher capacity molds always have to be custom made?
×
×
  • Create New...
Top