Jump to content

Covid19mademedoit

TU Member
  • Posts

    6
  • Joined

  • Last visited

Covid19mademedoit's Achievements

Newbie

Newbie (1/14)

1

Reputation

  1. After more thought, I would not do it either. This isn't only about speed for me but satisfaction of adding to my overall experience of my passion for fishing. Thanks for the input.
  2. That thread nailed it. Thanks!! Looking forward to being more consistent.
  3. Can the mold also be cooled by dipping in water between injections? I figure if it’s done each time it wouldn’t have too much of a shock.
  4. Ok, I will. I’ve been keeping notes but will try to avoid mistakes prior to making them if possible.
  5. I am using the essentials soft plastic kit from do-it molds. It has an injector. About 10% of my senkos have a small void. I was guessing that it was some kind of air pocket. I am very low volume guy too. Didn’t have an old microwave, had burner. If I can keep the plastisol between 320-360; should I expect any solidification in the pot? Thanks for the quick reply btw!
  6. Does plastisol solidify if overheated? What is everyone using as a heat source? I have been using a propane candy burner with an inverted cast iron pan over the flame and then an aluminum pan with a pour spout to melt it. Tips, pointers, criticism welcome. Super newb here. Also, I didn’t consider this at first but how do I prevent air bubbles/voids.
×
×
  • Create New...
Top