lunker05

Clear coat please helP?????

6 posts in this topic

Hello all, I sure could use some advice. I am looking for a good clear coat to put onto a buzzbait. It is a poured head with createx paint. I am not sure if I need the devcon or if I can just spray on some dick nites. I was trying to get away from a drying wheel so any advice would be greatly appreciated.

Share this post


Link to post
Share on other sites

I use PPG DC4125 Ceramiclear.

It's expensive--- $200 a gallon but will rival any cleacoat on the market.

Shoot it thru an air brush

No turning on a drying wheel.

It sets pretty quick " no runs- no drips" so just hang it and let it dry.

Regards, Blades

Share this post


Link to post
Share on other sites

Thin coats no wheel needed. I do my spinnerbait heads with 2T and don't use the wheel. As long as it's thin it won't sag. And you can do a ton of them in one small batch.

Although if you have some dick nites that'll be fine too.

Share this post


Link to post
Share on other sites

Blades,

Is the PPG DC4125 a one part clear or 2 part? I checked the website and it said it is formulated to use with the DCH4126 Hardener. If a hardener is used, what kind of pot life does it have?

Share this post


Link to post
Share on other sites

If you already have Dick Nite, just dip it in and hang it up, repeat after 24 hrs and let it cure for 4-7 days before fishing.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now