borderbasser

envirotex lite question

6 posts in this topic

How long does it normally take for this stuff to become non-tacky at room temp so that it can be handled. I tried it this time instead of the Devcon, but I no longer have the instructions. Thanks.

TJ

Share this post


Link to post
Share on other sites

DON"T touch it for about 12 hours - even if it is not tacky you will probably leave fingerprints on it, the oil of your prints sticks to the coat and you will have to polish them off - I know you will be dying to grab hold of, and inspect them - after all your work it's not worth the risk. 24 hours is even better. pete

Share this post


Link to post
Share on other sites

When I used Etex I would time it right ( just lucky I guess) and hang mine on the turner and spin all night ( blessed with a silent motor ). I would normally wait until I had at least 10-12 baits before doing this since 12 is the limit on my dryer. That way the next day I would'nt have to worry about tackiness. ;)

Share this post


Link to post
Share on other sites

Thanks guys. I guess it just takes a little longer than the Devcon. I was a little nervous about it but all was good this morning. Thanks again.

TJ

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now