Jump to content
Buckeye1955

wire bend question

Recommended Posts

Hi,

I recently starting making an in-line Buzz Bait using the wire forms from Barlows. They have a pre-formed loop on one end with the excess looped around the shaft a couple times. I would like to make the same type of loop for strength on the other end. I purchased one of the $25 wire benders from Barlows, but haven't had alot of luck because the buzz bait blade makes it difficult to fit the wire in the bender correctly. I get some pretty decent bends, but haven't figured out how to make the wraps without just brute force. That doesn't leave a very professional look. Any suggestions?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...
Top