pikeman1 Posted February 26, 2008 Report Share Posted February 26, 2008 looking for the instructions to make a custom mold from watter putty. I know triton mike had it posted at one time but I can't get it to open on this site or his web site, can any post it. Thanks. Quote Link to comment Share on other sites More sharing options...
charkins Posted February 26, 2008 Report Share Posted February 26, 2008 Here is a tutorial on making 2 part molds from POP. The procedure would be basically the same. http://www.tackleunderground.com/forum/showthread.php?t=5393 I made pop prototype jig molds many years ago. The POP would not stand the heat from continous use. (My opinion, others may differ) I have never used water putty for jig molds, but I have made many molds for soft plastic use. I doubt that the water putty would hold up much better than the POP. hope this helps. Quote Link to comment Share on other sites More sharing options...
kelly Posted February 26, 2008 Report Share Posted February 26, 2008 I tryed the water putty and the life was short. But a good way to test an idea before getting a custom mold made. Quote Link to comment Share on other sites More sharing options...
