.dsaavedra.

how do i change coping saw blade?

4 posts in this topic

ok i got it. it just took a lot of pressure to bend the frame so it would fit.

dont i feel dumb now :huh:

Share this post


Link to post
Share on other sites

On mine, you only need hold the frame and unscrew the handle to take the tension off the blade. Then remove and replace the blade. Try that on yours maybe?

Edited by fatfingers
Stupid typing errors

Share this post


Link to post
Share on other sites

well, to remove the blade, all you have to do is hold the little tab that is closest to the handle, and then twist the handle off.

but the blades are shorter than the frame is, so to put them on you have to secure the blade in one end of the frame and then push down on the frame to bend it so the blade can reach the other end of the frame. then secure and tighten handle.

i guess they did this so the blade would be under a lot of tension so it doesnt move a lot.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now