Jump to content
Techniques you use to apply your clear coat.
23 replies to this topic
Posted 23 September 2008 - 04:43 PM
The hard part is getting it to rollover on its back so you can get some of the softer hair. That is funny!!!
Corey, it really aint dat hard. just scratch him 'hind his ears a while, and he will be like putty in your hands.
Posted 23 September 2008 - 07:32 PM
I'm still trying to figure out which part of the badger do you use to make the airbrush.
Posted 23 September 2008 - 10:06 PM
The mouth, of course.
Posted 28 September 2008 - 04:11 PM
Good to see you back again. Stick with the two part expoxies, they cannot be beat so far. I still use the same old disposable brushes with the bristles and it probably takes me two minutes per lure to get two coats on which I don't think is too bad. I have tried and tried to find a clear coat that I can dip with no success.
In my humble opinion and no disrespect to others that like it, Dick Nite stinks to high heaven and goes on too thin. Component System also goes on too thin and isn't hard enough to provide good protection. I have also tried spray can lacquer and a sprayable car finish, too thin also.
I considered a UV cure epoxy, tried one but it took too long to set up. If you have the money for the expensive lights this might be the best option for production.