Jump to content
21xdc

Finally built a drying wheel...

5 posts in this topic

After getting some good ideas here, I made one. :yay:

Sorry for the bad pic.. It's a 2 rpm rotisserie gill motor, square shaft hammered into a round hole through 2X4, cut square. Velcro on the wood and soft side velcro on the hobby knife.

This allows me to hold, paint, clear coat and just stick it on the wheel as I go.

DryingWheel2.jpg

Share this post


Link to post
Share on other sites

Thanks guys.... Depending on what I want, I can rotate horizontal or turn the hobby knife 90* and flip them end over end.

These are the hobby knifes I bought localy >> Browsing Store - Hobby Knife w/ Blade

7502 - HOBBY KNIFE WITH BLADE

Michigan Industrial Tools/

Cheaper than anything else I have found. :yes:

Edited by 21xdc

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×