21xdc Posted November 3, 2008 Report Share Posted November 3, 2008 After getting some good ideas here, I made one. Sorry for the bad pic.. It's a 2 rpm rotisserie gill motor, square shaft hammered into a round hole through 2X4, cut square. Velcro on the wood and soft side velcro on the hobby knife. This allows me to hold, paint, clear coat and just stick it on the wheel as I go. Quote Link to comment Share on other sites More sharing options...
mark poulson Posted November 3, 2008 Report Share Posted November 3, 2008 Looks good. Clever idea about the velcro. Keep it clean, and it should last forever. Quote Link to comment Share on other sites More sharing options...
captsully18 Posted November 3, 2008 Report Share Posted November 3, 2008 Yup, the velcro is a clever idea. I like it. Looks quite functional. Good job. David Quote Link to comment Share on other sites More sharing options...
Vodkaman Posted November 3, 2008 Report Share Posted November 3, 2008 Velcro! Another good addition to the pool of drying wheel ideas. Nice one. Dave Quote Link to comment Share on other sites More sharing options...
21xdc Posted November 4, 2008 Author Report Share Posted November 4, 2008 (edited) Thanks guys.... Depending on what I want, I can rotate horizontal or turn the hobby knife 90* and flip them end over end. These are the hobby knifes I bought localy >> Browsing Store - Hobby Knife w/ Blade 7502 - HOBBY KNIFE WITH BLADE Michigan Industrial Tools/ Cheaper than anything else I have found. Edited November 4, 2008 by 21xdc Quote Link to comment Share on other sites More sharing options...
