Jump to content
holders for drying wheel
2 replies to this topic
Posted 17 January 2004 - 12:55 PM
I can build a drying wheel. but can't figure what to use for holders. I'm making 2 to 3 oz. lures, so they get a lot of leverage as they make a ratation.so I need something that holds them staight. I've seen a design where they are held at both ends, but, it looks as it would be hard to hook them up, after they are covered with envirotix. Thanks Doug
Posted 17 January 2004 - 05:02 PM
Check out "Lure Holders for painting" Item 10 on this forum. It works for me.