Does anyone have a good source for Indiana blades and crane swivels already assembled on split rings? I've starting making a crappie bait with tiny blades and the assembly is just killer, not at all like the spinnerbaits I used to make.
Bud
Navigation |
 1
3 replies to this topic
#2
Advanced Member
Posted 02 September 2010 - 08:25 PM
Bud,
I don't have a source for you on assembled blades and split rings. For years I've been using butt rings on pony head jigs and tail spinners, and you can't beat them. They are easy to put on and a lot less cheaper in cost than split rings. Trust me unless you are putting these on magnum spinnerbaits these things will never let go. If you want a couple of samples PM me and we can discuss it further. Edited by cadman, 02 September 2010 - 08:26 PM. #3
New Member
Posted 02 September 2010 - 09:03 PM
Bud, I don't have a source for you on assembled blades and split rings. For years I've been using butt rings on pony head jigs and tail spinners, and you can't beat them. They are easy to put on and a lot less cheaper in cost than split rings. Trust me unless you are putting these on magnum spinnerbaits these things will never let go. If you want a couple of samples PM me and we can discuss it further. It's saying you can't receive any more messages. I've never used butt rings. I would like to get more information. Bud #4
Advanced Member
Posted 02 September 2010 - 10:12 PM
It's saying you can't receive any more messages. I've never used butt rings. I would like to get more information. Bud Bud, I've had this problem before with my PM's. Anyway I'm going to PM you my e-mail and send me an e-mail and I will help you out. Until I get this problem resolved.......................Thanks |
