Jump to content

- - - - -

Removing Middle Seat And Putting In Floor

  • Please log in to reply
2 replies to this topic

#1 martin790


    New Member

  • TU Member
  • Pip
  • 1 posts
  • Location:
    south carlonia

Posted 07 September 2010 - 05:51 AM

I have a 14' v bottom jon boat i would like to relove the middle seat but not sure if it will hurt the duribilty of the boat. the picture i drew up in the attachment is how my bench seats sit in the boat.

Attached Files

#2 Musky Glenn

Musky Glenn

    Advanced Member

  • TU Member
  • PipPipPip
  • 710 posts
  • Location:
    Marion, N. C.

Posted 07 September 2010 - 08:10 AM

I had a 15' jon boat that didn't have a middle seat and they hadn't done anything special to strengthen the sides. This was from the factory that way. I would recommend that you don't use a strap across the top of the boat to attach it to the trailer, which would tend to pull the sides in. Just use the front eye and the two back eyes to hold it on the trailer, if you use a trailer. Musky Glenn

#3 gordon



  • TU Member
  • PipPip
  • 52 posts
  • Location:

Posted 25 October 2012 - 01:07 PM

I have a 17ft Aluminum open Jon boat with a tiller engine. I built it by converting an old Tracker Bass boat, ripping out the console ect in the middle. I also shortened the raised deck at the back by 2ft as I did not need livewells. I now have an 8ft lower deck. I have used this boat since 2006 with no problems whatsoever.