Sign in to follow this  
Followers 0
davey

Line Tie Placement For 1/2" Wide Basswood Crankbaits For Bass.

2 posts in this topic

making crankbaits for bass fishing out basswood. Crankbaits are about 2 1/4" long and 1/2" wide . Useing a F3 circuit lip from lurepartsonline. I would like the bait to run in 5 to 6 ft range. Where do I need to place the line tie and lip and angle to achieve this? I NEED HELP THANKS?

Share this post


Link to post
Share on other sites

Off hand, I'd say keep the line tie in the nose of the bait, tight to where the lip exits the bait, and run the lip at a 45 degree angle to the centerline of the bait. A flatter angle will cause the bait to run deeper, but you may have to put the line tie into the lip a little.

Think of a RC 2.5, and you'll have a good jumping off point for a crank that size.

You can also take a look a one of the Rapala DT (dives to) series that gets down to the depth you want, and see how it's lipped and where the line tie is located.

Every crank has a slightly different shape, buoyancy and center of gravity, so you'll probably still have to play around some.

Also, the shape of the lip also bears on how deep it goes, and how stable it is, too.

If it were easy, I'd do it! :lolhuh:

1 person likes this

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0