0
i made a good drying rack out of a wire coat hanger.I just bend it to fit the lures i made and can be made long or wide depending on how your bait are made just bend it to size putting kinks where you want the baits to sit on the top n bottom and straighten out the hook so it can be clamped in a vara speed drill(I used a b&d charger type two speed on low speed),put paper clips on the wire were the lower
part will be,Then get some thick rubber bands and put them on the upper ends with a paper clip attached to it for the bait to clip to. Clip the paper clips to the lure front and back so the rubber band holds it tight and e-tex the bait and let it spin (mine spins about 10 rpm)
