Jump to content
Airbrush And Airbrush Paint Issue
3 replies to this topic
Posted 13 January 2012 - 06:39 PM
Couple of questions I hope you guys can help me with. 1- I have found some of my createx paints too thin right out of the bottle. Is there anything I can add to the paint to thicken it up? 2- When I push down on the airbrush trigger to get the air started some paint comes out when I haven't moved the trigger back to start paint flow. Not sure how to remedy that. Its an Iwata Revolution CR. Thanks for any advice
Posted 13 January 2012 - 07:33 PM
It isn't the paint, It sounds like dried paint on the needle and it isn't seated right. Pull the needle and the caps and clean off/out the dried paint.
Posted 13 January 2012 - 08:21 PM
If the Createx paints that are too thin are the fluorescent paints then I think that's just the nature of the beast. I don't know of anything that can be added to thicken them.
And I agree with 152nd on the other problem.