Jump to content

- - - - -

Tail Weight Mold

  • Please log in to reply
1 reply to this topic

#1 archeryrob



  • TU Member
  • PipPip
  • 173 posts
  • Location:
    Fairplay, MD

Posted 17 January 2012 - 10:38 AM

Anyone here make a tail weight mold. The type of round weight like an in line lure body but with a larger hole.

The do it mold only goes up to 3/8 and the hole is for under .035 wire which might be a little too light for stripers and blues

#2 crankpaint


    Advanced Member

  • TU Member
  • PipPipPip
  • 304 posts
  • Location:

Posted 17 January 2012 - 05:08 PM

you can make one just like the belly weight mold in the tutorial or use that to do the same thing?i just drill a hole in the tail add my hook hanger and pour the lead into the hole,and if your worried about the hanger pulling out you can pin it in by putting a peice if wire/small nail thru the side i=of the bait so it gos thru the hole were the lead will go to hold it in place