dochollow Posted April 22, 2012 Report Share Posted April 22, 2012 puled your freshly finished lures off your dryer and find a missed spot do you just re hit the spot, or re coat the entire lure :?thanx, doc. Quote Link to comment Share on other sites More sharing options...
dochollow Posted April 22, 2012 Author Report Share Posted April 22, 2012 sorry, using D2T Quote Link to comment Share on other sites More sharing options...
Fishsticks Posted April 22, 2012 Report Share Posted April 22, 2012 I think if you just hit the spot you will still see it. Best to just recoat the lure, can try to thin the epoxy if you don't want it to be too thick. 1 Quote Link to comment Share on other sites More sharing options...
littleriver Posted April 23, 2012 Report Share Posted April 23, 2012 X2 Quote Link to comment Share on other sites More sharing options...
Tracy G Posted April 23, 2012 Report Share Posted April 23, 2012 I usually re-do the whole thing. UNLESS I catch it while the epoxy is still tacky, then I will hit the one spot. Quote Link to comment Share on other sites More sharing options...
RayburnGuy Posted April 23, 2012 Report Share Posted April 23, 2012 I've had this same problem before and re-coated the whole lure. Turns out you could still see the bad spot even though it was covered in epoxy. It was a little low in that area after the second coat and was definitely noticeable. I would recommend doing a spot repair and after it cured sand it down until it was smooth with the surrounding area. Then I would re-coat the whole lure. And it wouldn't hurt to go over the whole bait with some 400 grit so the fresh coat has an extra little something to bite onto. Any scratches will disappear with the second coat of epoxy. That should give you a perfect finish. It all boils down to how much time and effort you want to put into it so the repair doesn't show. Ben Quote Link to comment Share on other sites More sharing options...
