Jump to content



Photo
- - - - -

Shaping Jitterbug Plugs


  • Please log in to reply
3 replies to this topic

#1 aaron4mvp

aaron4mvp

    Member

  • TU Member
  • PipPip
  • 52 posts
  • Location:
    Wisconsin

Posted 23 April 2012 - 02:52 PM

I was wondering if any of you make jitterbug type lures?

If you do, what do you use to shape the mouth where the jitterbug bill goes. I bought some lips from lure parts online and was wondering what to use to shape the lure so the bill fits against it.


I was thinking maybe a band saw or end of the belt sander, but thought maybe somebody has a different way of doing it?

#2 diemai

diemai

    Advanced Member

  • TU Sponsor
  • PipPipPip
  • 2,190 posts
  • Location:
    near Hamburg/Germany

Posted 24 April 2012 - 06:23 PM

@ aaron4mvp

I've made a few before , ..turned them down on a lathe out of buoyant abachewood , .......made them in a kind of elongated teardrop shape , also a bit tapered towards the rounded nose .

Sanded down the lip plane on a sanding disc freehanded , ...should sit at 45° to the blanks center axis .

The shaping of the nose on the lathe requires planful processing , ........if it becomes tapered and rounded too pronounced , the sanded 45° plane might become too short for all the mounting screws covering it , ...or , ...in other words , ....you might have to sand off quite a bit of material from the nose to achieve a sufficiently long plane for coverage of the screws .

For my first one I've used stainless steel lips , but found these to be too heavy , ...my Jitterbugs would never float up level this way but head-down , ........since I go for aluminium lips exclusively .

But I've also made Jitterbug-style lures out of rectangular timberboards , ...these also worked fine , ...have a look in my gallery :

http://www.tackleund...tyle-topwaters/

Please check next(or previous ??) pictures as well .

Good luck , diemai :yay:

Edited by diemai, 24 April 2012 - 06:26 PM.


#3 garyo1954

garyo1954

    Member

  • TU Member
  • PipPip
  • 142 posts
  • Location:
    Elkhart, Texas

Posted 25 April 2012 - 02:56 PM

Went out and played around on this today.
First pic should give you an idea of the length.
I left the tag ends on so that I could take it from the lathe to a table saw, or miter box and cut the 45 degree angles.
The two halves will allow the use of a thru wire design.
Posted Image

Good pics of the 45 degree angle.I've also left a flat surface at the top and bottom.
That, and the taper, can be sanded or shaped.
Posted Image

You can there is about a 1" width for mounting the front lip.

Posted Image

Hope this gives you some good ideas. Good luck!

#4 woodNfish

woodNfish

    New Member

  • TU Member
  • Pip
  • 2 posts
  • Location:
    North East

Posted 05 April 2013 - 10:11 AM

 You can go and buy a jitterbug to use as a reference, and you will see that the lip is not at 45 degrees. It is closer to 30 degrees. You cn also see photos on the tackle websites like bass pro and cabelas, etc.