Sign in to follow this  
Followers 0
speechless33759

|=]==]=

3 posts in this topic

Hey guys, I've been experimenting with a resin pour with Microballoons. I'm using a 1:1 MB to hardener and 1:1 MB to resin ration. I'm not getting a good "Float" with the weights in, it'll hang sideways rather than straight up and down as I'd like. have any of you tried a higher ratio of MB to resin/hardener with success?

Share this post


Link to post
Share on other sites

IF your pouring along the back try pouring the lower half without the mb. and then adding them to the top half that would make the top lighter even more and might cure the prob.

Share this post


Link to post
Share on other sites

You need to send an PM to Coley. He is the best micro balloon person that I know. He has a ton of knowlege on the subject.

Skeeter

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0