markinorf 11 Report post Posted May 28, 2012 Need help finding .072" dia by 3/4" long. I can only find 1'' long in that dia. ?????? Tried all the usual places and everything in .072 starts at 1''. Thanks Share this post Link to post Share on other sites
bluetickhound 36 Report post Posted May 28, 2012 Have you tried McMaster Carr? They seem to have everything I need! Share this post Link to post Share on other sites
markinorf 11 Report post Posted May 28, 2012 Have you tried McMaster Carr? They seem to have everything I need! Didint think about MCarr! Thats where I got my butyrate stencil plastic. I searched the forum and found the screws at Moores tackle aslo. Woohoo! Thanx BTH. Share this post Link to post Share on other sites
RayburnGuy 1,341 Report post Posted May 29, 2012 Have you looked at the link below? Ben http://lurepartsonline.com/Online-Store/Screw-Eyes/ Share this post Link to post Share on other sites
CNC Molds N Stuff 484 Report post Posted May 29, 2012 (edited) H&H used to have a pretty good selection. Cabelas stocks some in open eye and closed eye. I don't know the diameter, but I've got a couple bags in the shop. I'll check it you like. Edited May 29, 2012 by Bob La Londe Share this post Link to post Share on other sites
markinorf 11 Report post Posted May 30, 2012 Have you looked at the link below? Ben http://lurepartsonline.com/Online-Store/Screw-Eyes/ Yep. no dice. Ray. Moores lures. I called but they must be recovering from the holiday weekend. H&H used to have a pretty good selection. Cabelas stocks some in open eye and closed eye. I don't know the diameter, but I've got a couple bags in the shop. I'll check it you like. Smae there. Starts at 1'' for .072. Share this post Link to post Share on other sites
RayburnGuy 1,341 Report post Posted May 30, 2012 If you can't find the 3/4" screw eyes in the 0.72 size, and they absolutely have to be that size, then get the 1" and trim off a quarter inch. You can cut off a quarter inch with any number of tools and sharpen a point back on them if need be. If your predrilling the holes for the eyes then they wouldn't even need a point put back on them. Ben Share this post Link to post Share on other sites