Jump to content
I'm Painting Some Old Pikies......need Help.
4 replies to this topic
Posted 22 August 2012 - 05:54 AM
I have a bunch of old Pikie Minnows for the 40's and 50's that I've striped down and am ready to repaint. I've done a lot of painting on plastic with laquer but not too much on wood. I'm trying to find out the best way to go for primer and clear coat. I''ll be using acrylic paint. I'd also like to stick with a one part clear as sometimes I only have the time to paint one bait and mixing clear for that can be a pain in the ass and a waste.
Posted 22 August 2012 - 06:38 AM
tim ya gotta seal them. then prime with kilz zinsser or lacquer prime
Posted 22 August 2012 - 08:45 AM
Personally I just use AA sealer white over clean sealed wood. 2 coats and u r good to go!
I have tried the automotive primer in a rattle can from walmart and it works good too. its thick stuff and will fill a little for you. draw back is its like $5 a can so i dont use it often unless i have a bait that I want to cover an old paint scheme or something. But if I sand it all the way down and have a good sealed clean bait then I just go with the AA sealer white.
Posted 22 August 2012 - 01:28 PM
What's the best to seal them with Woodie? I don't want them peeling and I don't really want to bother "someone" to do them for me. Also what about a one part clear? Any suggestions?
Posted 22 August 2012 - 03:43 PM
when you seal seal them2x scuff between coats bass wood cleaned accepts sealer. immeres in can deft or minwax or straight white shellac. scuff when dry then paint. clearcoats depend upon paints your using for patterns.