Jump to content
J lure

Jointed Swim Bait Pins......

Recommended Posts

I normally clear each part separate, then put the pins in and put a dab of epoxy over the pin hole. Of course, I was using either Dick Nites (dipping process) or envirotech (brushed, then turned). Both of these process wouldn't work with a jointed lure together, but a spray clear (like automotive) would probably work fine.

Link to comment
Share on other sites

On the pins I drill the holes slightly smaller than the pin so they already have a snug fit. I can use any kind of filler but lately I've been fitting the pins to the exact length and put a dab of superglue on them when I slide the last 1/4" in. Clearcoat over the top. I like thid because if I need to disassymble in the future it's easy to see the pin and drive it out with a punch. Screw eyes is a dab of superglue on the threads before they go in and again they are in before paint and clearcoat.

Edited by quickdraw
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...
Top