Sign in to follow this  
Followers 0
Seeking 56

Fyi, Various Wood Cuts

2 posts in this topic

As quoted from the internet:

 

" Plain Sawing:
 

The most simple method for milling a log into planks, plain sawing, involves making a series of parallel cuts through the log. This method is quick and leaves the least amount of waste. Because of the directional tension across the grain as the wood dries, ages and wears, flat sawn boards can be subject to cupping, twisting and bowing. Often, dry boards will absorb moisture from the atmosphere and will become distorted. Plain sawn lumber has a large variety of appearances based on the angle of the growth rings relative to the surface of the board. Often, these rings can be nearly parallel to the board, creating large, open patterns. When the angle of the growth rings nears perpendicular to the surface of the board, there are tighter stripes across the face of the plank.

 

Quarter Sawing:
 

To create quarter sawn lumber, the log is first cut radially into four quarters. Once quartered, there are two different ways in which boards are extracted from the log as shown in the photo below. The upper method is more complex and labor intensive, but leaves far less waste from the log. The method on the right hand side can be executed quickly, simply plain sawing the quartered log. However, this technique leaves large amounts of waste wood. In a quarter sawn board, the growth rings of the tree are closer to perpendicular to the surface of the board than in most plain sawn boards. In certain species of wood, most notably Oak,  this creates a beautiful visual effect.  These boards are more stable than plain sawn, being less susceptible to distortion that comes with expansion and contraction from absorbing and releasing atmostpheric moisture. Stable quarter sawn lumber is often recommended for flooring in high moisture, high traffic areas like restaurants, bars and home kitchens.

 

Rift Sawing:
 

The most stable boards, and also the most wasteful to produce, are rift sawn planks. Each of these boards is cut radially perpendicular to the growth rings of the tree. There are large triangles of waste left from between each board. As a result, rift sawn lumber is costly to produce and therefore, the most expensive type of planks available from a log. "

Quarter-Sawn.jpg

Quarter-Sawn.jpg

Quarter-Sawn.jpg

Quarter-Sawn.jpg

Quarter-Sawn.jpg

Quarter-Sawn.jpg

Quarter-Sawn.jpg

Quarter-Sawn.jpg

post-18480-0-02952900-1356221054_thumb.jpg

Share this post


Link to post
Share on other sites

good post. question. when buyingwood why is so called kiln dried a joke left outside at stores to absorb moisture lol. just a peeve i guess

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0