jigflipper Posted June 3, 2004 Report Share Posted June 3, 2004 Hi folks! I've got several baits that I painted a while back, and have decided that I just do NOT like the finished products. The lures were coated with Devcon 2 Ton. I'm wondering what would be the best way to remove the D2T in order to get to the paint. Would sanding be the way, or is there an easier "chemical" method? Thanks in advance! Jigflipper Quote Link to comment Share on other sites More sharing options...
Skeeter Posted June 3, 2004 Report Share Posted June 3, 2004 Acetone will remove the Devcon. Skeeter Quote Link to comment Share on other sites More sharing options...
SeminoleFan Posted June 3, 2004 Report Share Posted June 3, 2004 you can also boil the baits to remove the devcon. But beware.. dont boil them to long or they will swell. I would boil them for about a minute. remove.. peel off the devcon.. boil again for about a minute.. peel off the devcon. it works. Quote Link to comment Share on other sites More sharing options...
Hughesy Posted June 3, 2004 Report Share Posted June 3, 2004 If you can get a pocket knife point just under the devcon and get a hole started, you can just peel it off. Quote Link to comment Share on other sites More sharing options...
RiverMan Posted June 3, 2004 Report Share Posted June 3, 2004 It's too bad you hadn't used Envirotex, then all you would have to do is fish with it for a couple hours, lol!! Isn't DAT RIGHT CHIP. Jed Quote Link to comment Share on other sites More sharing options...
Chip Posted June 3, 2004 Report Share Posted June 3, 2004 Actually its the other way round R-Man Just go beat them lures on the water for a couple hours...... when the crack forms, your almost there...... continue to beat on the water and it will just peel right off! Yall take care! p.s. that really works! Tested, tried and True!!! Quote Link to comment Share on other sites More sharing options...
