Jump to content
Epoxy for clear coating?
2 replies to this topic
Posted 21 June 2004 - 09:21 PM
New to the art of bait making, been reading about using epoxy for the clear coat, I take it this is brushed on? Or dipped? Sombody help
Posted 21 June 2004 - 09:57 PM
The epoxy mentioned here is Devcon 2 Ton or what they
call 30 min. epoxy. Walmart sells it, It's packaged in a
double syringe tube, it disperses equal amounts at the
same time. After mixing throughly apply it with a brush.
Walmart also sells a good brush in the model car section
of the store. Cost is 97 cents. You can clean it out with
Acetone after use. After applying the epoxy to your
bait, you must rotate the bait until the epoxy is set or it
will sag and run. Rotation can be done by hand for
about 20-30 min or you can build a dryer to rotate your bait
while the epoxy sets.