Jump to content
jrhopkins

Envirotex Question

Recommended Posts

To give yourself the best chance of a avoiding the obvious running downwards try and get it on a turner or by hand if its done manually, also warm the etex first by putting the bottles in hot water..not boiling though! leave for at least 30 mins this will thin the etex and create less bubbles, mix thoroughly and leave in a warm place for  a while, this will depend on where you are because humidity affects the way etex behaves, 70-80 degrees is a good temp range.

 

Check after 10-15 mins and it should now be starting to thicken, if not leave another 10 or so, then apply, it should have less chance of running if its thicker obviously, then keep an eye on it and turn every 5 mins if done manually, it should be ok to leave after a few hours if left in warm conditions of about 80 degrees.

Edited by DaveG
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...
Top